/ / / Edge Sol Cleaner

Shop

Edge Sol Cleaner

​ ​ ​

Alkaline Tank cleaner with FOAM nature, which have high solvency power on soil and oily greasy matter.

SKU: RXSOL-16-3014-025 Category:

Description

Alkaline Tank cleaner with FOAM nature, which have high solvency power on soil and oily greasy matter.  Formulated with properitory superior Heavy duty and highly concentrated  water based alkaline cleaner, containing specially selected detergents and powerful long chain organic syndet ,specific salts with surfactants & wetting agents. It is low toxic product with an exceptional solvency power on soil & oily  matter & having good foaming qualities. It is free from Hydrocarbon solvents , Biodegradable and minimizes the extreme hazards to personnel in handling materials . Also suitable for TANK CLEANING .It can be used as a general purpose cleaner to remove oil and grease deposits.






Product Details

Application

Can be used for gas and hydrocarbon freeing of tanks.
 

Dosage & Procedure

First of all, flush the system with cold water to prevent evaporation rates and polymerization then the most economical method of using RXSOL-16-3014 is by direct injection followed by recirculation washing, using tank cleaning machines.

Spraying method: Directly spray on the contaminated area and let it act for 5-10 minutes. Then clean the system under high pressure. A solution of 5-10% in fresh water can be used for this purpose also, and may be sprayed on and hosed off using high pressure.

Circulation method: Cleaning the oil side of the tank can be cleaned by circulating through with RXSOL-16-3014.

Rock and Roll method: fill the tank with water (fresh or sea) up to 25 - 30% of its volume than 5–20% (Depend on contamination) RXSOL-16-3014 will add, let it stand for approximately 12-24 hours. Then fill with more water to 90% of the tank's capacity. This way the tank will be cleaned by natural agitation due to wave motion. Let for a few days, then drain the tank and ballast-deballast 2-3 times in order to achieve complete and thorough rinse off.

Technical Specifications

Boiling Pt:B.P. Text:212F (100C)
Melt/Freeze Pt:M.P/F.P Text:N/K
Decomp Temp:Decomp Text:N/K
Vapor Pres:17.50 Vapor
Density:LTA Spec
Gravity:1.060-1.080
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:N/K
Appearance and Odor:CLEAR YELLOW LIQUID HOMOG SOLN Percent Volatiles by Volume:55-70 Corrosion Rate:

Notes & Precautions

Characteristics :
Removes grease, oil, carbon deposits, soil and grime.
Keeps loosened deposits in suspension preventing re-deposition.
Low toxic.  , Non-flammable.
Free from hydrocarbon solvents.
Effective and economical in use , Water-based cleaner.
RXSOL-16-3014 has numerous cleaning applications including removal of greases, waxes, oil, sludge, soot,
carbon deposits and general dirt and grime.
Non-corrosive to ferrous metals.  Suitable for all tank-coatings.
Can be used for gas and hydrocarbon freeing of tanks.
Can be used for deodorizing


Can be used for deodorizing
Contains wetting agents.
Suitable for accommodation cleaning of woodwork, leather, desks, etc.
Suitable for cleaning of toilets and showers.
Suitable for cleaning of reefer boxes.
Can be used for cleaning of windows and portholes. Also used for cleaning of dishes.
Can be used for cleaning of hospitals.
Can be used for hand laundry cleaning.

Generic / Chemical Name

Tank Cleaner for Hydrocarbon Free

Supply Locations

Edge Sol Cleaner manufacturer supplier distributor in Mumbai, Kandla, Kolkata, Vizag, Chennai, India, Fujairah, Dubai UAE, Muscat Oman, Kenya Africa. Get the best quality of Edge Sol Cleaner at a competitive price from us. We have ready stock of Edge Sol Cleaner in India, UAE Gulf, Oman, Kenya Africa. Contact us for bulk as well as small orders.

Safety Data (MSDS)

Product Name RXSOL-16-3014
Product Type EDGE SOL CLEANER

Company Details:

RX MARINE INTERNATIONAL
105, A wing , BSEL , TECH PARK.
VASHI ,NEW BOMBAY 400703 INDIA

Phone +91 22 27815540 / 41 / 42
Fax +91 22 2781 1318 :::AOH :0091 9821214367
Email mail@rxmarine.com

Oxidation blowing and chemical reaction of Fatty alcohol derivative, non-ionic surfactants,phosphate and remaining which is not in the list of hazardous materials. *See Section 16
DODECYLBENZENESULFONIC ACID, SODIUM SALT CAS:25155-30-0 RTECS #:DB6825000 Fraction by Wt: Other REC Limits:N/K OSHA PEL:N/K ACGIH TLV:N/K EPA Rpt Qty:1000 LBS DOT Rpt Qty:1000 LBS
SODIUM PHOSPHATE, TRIBASIC (SARA III) CAS:7758-29-4 RTECS #:YK4570000 Fraction by Wt: Other REC Limits:PEL=15 MG/CUM EPA Rpt Qty:5000 LBS DOT Rpt Qty:5000 LBS
(Z)-9-OCTADECENOIC ACID CAS:112-80-1

Environmental Hazards

None ( > 90% INGREDIENTS are bio degradable.)

Human Health  Hazards

Moderates

R 36/38: Irritating to eyes and skin. 

Inhalation

Supply or remove to fresh air , Not relevant

Skin Contact

Rinse with running water and soap. Remove contaminated clothes.

Eye Contact

Flush with running water for at least 15 minutes Immediately .

Ingestion

Seek medical attention , try to drink more fresh water. 

                                              

Non combustible product

Suitable   N.A.

Can use all extinguishing media like foam dry Co2 , water-spray.

Not suitable

Not applicable 

Special

Not applicable

Protection of fire Fighter

Not applicable  

Precaution for fire-fighters

Wear protective equipment.

Enviromentel Precaution

Direct flow into drainage system, surface or ground water is  prohibited.

Cleaning  Method

Flush Spill Area with Water and remove with liquid-absorbing material like foam sand,sawdust etc.

Condition to Avoid

Non flammable but avoid direct heating

Materials  to Avoid

Do not subject to Acidic / Oxidizing Agents.

Handling

Keep Container Tightly Closed
NOTE: Eyewash facilities require at workplace The product causes corrosion on skin and mucous membranes Pl. Note that In case of discharge of acidic or alkaline products into the sewerage system the pH must be in the range of 6-10 since higher or lower pH values may damage the sewerage system or impair biological dosagetreatment plants.So that for maintaining pH we have to add acidic / basic medium neutaliser . For example if pH is less than 6 basic neutraliser is required and if pH is more than 10 acidic nature neutraliser is required. For details of any guideline pl. Visit our technical website www.rxmarine.com  Dilute in water (always use plastic jar and RXSOL should be added to  water  never add water to RXSOL.)

                                                                                                                                                                    

Product Properties

Appearance

Clear liquid   

Density     

In g/cm3 at 20°C: 1.1  

Compatibility  

 

Metal     

No known effect   

Rubber 

No known effect   

pH  

Alkaline ( 12.5 ) .

Flash point

Not Applicable  

Solubility 

100% soluble in water 

Hazardous Decomposition Products:
Do not occur if stored and used as directed. In FIRE combustion CO, CO2 , NH3 , SOX etc hazardous gas produced.
NOTE AVOID CONTACT WITH ACID

 Comment - Not applicable , Emulsifies in water . Product is giving irritation on skin.

95 % added surfactants are  biodegradable as per by international regulation .But strictly This material must be disposed with local national regulations.

As per guide line of local rules and regulation and before disposal and neutralization pl. refer 07 article.

Not a hazardous material according to RID/ADR, GGVS, GGVE, ADNR, IMDG, ICAO- TI/IATA-DGR

Classification and labelling according to Chemicals Hazard Information and Packaging Regulations (CHIP).

Symbols of danger

Xi Irritant

 R-phrases

R 36/38 : Irritating to eyes and skin

S-phrases

S26 : In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
S28 : After contact with skin, wash immediately with plenty of water.
S37/39 : Wear suitable gloves and eye/face protection.

This information is based on our current level of knowledge and relates to the product in the state in which it is delivered. It is intended to describe our products from the point of view of safety requirements and is not intended to guarantee any particular properties.

DISCLAIMER OF LIABILITY :The information in this SDS was obtained from sources which we believe are reliable. However, the information is provided without any warranty, express or implied, regarding its correctness. The conditions or methods of handling, storage, use or disposal of the product are beyond our control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of the product. This MSDS was prepared and is to be used only for this product. If the product is used as a component in another product, this MSDS information may not be applicable.

Related Products

top