Shop

RXSOL-16-1004-025

 COMPONENTS-CHEMICAL NAMES AND COMMON NAMES

CAS Number

Applicable PEL-OSHA

Exposure Limits TLVACGIH

ETHYLENE GLYCOL MONOBUTYL ETHER

PRIMARY ROUTES OF ENTRY:

INHALATION, INGESTION, SKIN ABSORPTION, EYE

ACUTE EFFECTS

Systemic: CNS depression producing headache, dizziness, numbness, loss of consciousness.

Inhalation:

Irritation of upper respiratory tract. Exposure to high concentrations may cause systemic toxicity. Aspiration into lungs can cause chemical pneumonitis 

Eye Contact:

Irritation.

Skin Contact:

Dermal irritation & dermatitis attributable to defatting of skin.

Ingestion:

Irritation of gastrointestinal tract. See also systemic effects above

Eye  Contact:                     

Flush with water for 15 minutes. Get medical attention.

Skin Contact:

Flush skin with water then wash with soap and water. If irritation occurs, get medical attention.

Inhalation:

Remove to fresh air. If not breathing, administer artificial respiration. Get medical attention.

Ingestion

DO NOT INDUCE VOMITING. Drink 3 to 4 glasses of water. Get immediate medical attention. If vomiting occurs, keep head below hips to  prevent aspiration.

FLAMMABILITY as per USA FLAME PROJECTION TEST (aerosols) 

N/A

PERSONAL PRECAUTIONS

Avoid contact with skin and eyes. Provide eyewash bottle with clean water. For personal protection, see section 8.

ENVIRONMENTAL PRECAUTIONS

Do not allow to enter drains, sewers or watercourses. If substance has entered a water course or sewer or contaminated soil or vegetation, advise the appropriate authorities.

SPILL CLEAN UP METHODS

Steps To Be Taken If Material Is Spilled Or Released:

Do not allow large spills to contaminate sewers, ground or surface waters. Contain spill & soak up in inert absorbent material. Place in leak-proof  containers for proper disposal.

Waste Disposal Methods:

Dispose of in accordance with all local, state and federal regulations

Respiratory Protection (specify type):

None required under normal conditions of handling and use.

Protective Gloves:

Solvent resistant

Eye Protection:

Chemical goggles.

Boiling Point:

180°C

Specific Gravity (H2O=1): 

0.85-0.91

Vapor Pressure:

Vapor Pressure (Non-Aerosols)(mm Hg and Temperature):

N/D

Vapor Density (Air = 1):

>1

STABILITY

[ X ] STABLE [ ] UNSTABLE

HAZARDOUS POLYMERIZATION

[ ] WILL [ X ] WILL NOT OCCUR

Incompatibility (Mat. to avoid):

Strong oxidizing agents.

Hazardous Decomposition Products:

Oxides of nitrogen, carbon, hydrogen chloride, unidentified organics.

Read safety instructions, SDS and emergency procedures before handling.

Not established.

The information above is believed to be accurate and represents the  best information   currently    available  to us.  However,   we   make no warranty of merchantability or any other warranty, express or implied, with respect to such information, and  we assume  no liability resulting from its use. Users should make  their  own  investigations  to determine the suitability of the information for their particular purposes. In no event shall be liable for any claims, losses, or damages of any third party or for lost profits or any special, indirect, incidental, consequential or exemplary damages, howsoever arising, even if RX Marine International  has been advised of the possibility of such damages.

DISCLAIMER OF LIABILITY :The information in this SDS was obtained from sources which we believe are reliable. However, the information is provided without any warranty, express or implied, regarding its correctness. The conditions or methods of handling, storage, use or disposal of the product are beyond our control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of the product. This MSDS was prepared and is to be used only for this product. If the product is used as a component in another product, this MSDS information may not be applicable.