DRY ACID DESCALEX

RXSOL AC-2 chemical is specialized detergent based acid with corrosion inhibitor for evaporators, boilers, heat exchangers, tanks, pipes, and other heat transfer equipment

SKU: RXSOL-42-1304-025 Category:

Description

RXSOL AC-2 effectively not only cleans scale but also protect from rust. RXSOL AC-2 chemical is specialized detergent based acid with corrosion inhibitor for evaporators, boilers, heat exchangers, tanks, pipes, and other heat transfer equipment which are commonly fouled by scales, corrosion and other impurities.
 
RXSOL AC-2 effectively remove scale, rust and lime deposits from metal surface.





Product Details

Application

Powder scale remover designed for use in the chemical cleaning of evaporators, boilers, cooling towers, heat exchangers, tanks and pipes, which are commonly fouled by hard water scales, grease, tarts and other impurities.

RXSOL DESCALE contains corrosion inhibitor which provides corrosion protection even after the cleaning, unlike other acid cleaning chemicals which may increase corrosion rate after cleaning. Moreover, it contains pH indicator which facilitate monitoring of cleaning progress.

 

Dosage & Procedure

Directions for Use and Dose Rates
The most effective descaling is accomplished by circulation. In the case of small components, the soak method in an immersion bath can be used. If the equipment to be cleaned is contaminated by oil, grease and sludge, then pre-cleaning with RXSOL NEW org Plus or Enviro Degreaser. Depending on the extent of scaling, use a solution of 2.5-10% Descale Powder. The solution will have a red colour which disappear when the solution is neutralised. Whenever possible, the solution should be heated to 60°C. Neutralised solutions can be reactivated by adding more Descale Powder until the red colour reappears. This should not be done more than twice. Descale Powder should not be used on aluminium, zinc, tin or galvanised surfaces. Descaling of Boilers, Descaling of Diesel Engine Cooling Water Systems, Condensers,

Evaporators, Calorifiers, Heat Exchangers:
The strength of the acid can be enhanced by adding 1 part sodium chloride (common salt) to 20 parts of Descale Powder. This enhancement of the cleaning solution, however, should not be used when descaling diesel engine cooling water systems. After use of Descale Powder a 0.5% solution of Alkalinity Control in fresh water should be used for neutralisation.

Technical Specifications

 

Appearance

Yellowish Powder

Density

in g/cm3 at 15°C: 1.2

Flash Point

(PMCC) in °C: N/A  

pH

in 10 wt-%: 1.1

Compatibility

 

Metal

Avoid Aluminium, Zinc, Tin and their  alloys and Galvanised surfaces. 

Rubber

No known effect. 

Notes & Precautions

Descale powder blended with corrosion inhibitor along with scale removing acidic powder for cleaning of rust and water scale deposits from water system. Presence of Inhibitor resulting to stop direct acidic effect on metal surface.
 

Descale  powder scale remover and cleaner formulated to remove rust and scale deposits from boilers, diesel engine cooling water systems, condensers, evaporators, calorifiers and heat exchangers.

RXSOL Descale contains corrosion inhibitor which provides corrosion protection.

This product is compatible and suitable with aluminium, copper, zinc, galvanized metals, steel boilers etc. Powder Acid for Removal of Scale and Rust

Active Matter

93-98

Generic / Chemical Name

Corrosion Protection Scale cleaning Detergent

Areas of Use

Descale Powder is used for descaling of ships' boilers and marine diesel engine cooling water systems. Also, refer this link to equivalent suitable product http://rxmarine.com/descaling-liquid-20-ltr

Supply Locations

Decale Powder Powder manufacturer and supplier in Muscat - Barka, Oman, Fujairah, Abudhabi, Ajman, Sharjah, Dubai, Diera, UAE Middle East, Mumbai, Kandla Gandhidham, GIDC SURAT, Navi mumbai MIDC, Taloja, Panvel, Nerul, Koparkhairna, Turbha Mahape, Rabale, Airoli, Kolkata, Howrah, West Bengal, Bihar Patna, Dehri On Sone, Jharkhand, Ranchi, Tata, Dhanbad, Varanshi, Uttar Pradesh UP, Visakhapatnam, Andhrapradesh, Manglore, Goa, Nairobi Kenya Africa, Sudan, Yemen

 

RXSOL Decale Powder improves heat transfer efficiency in heat exchangers and improve flow in pipes.
RXSOL Decale Powder effectively dissolves calcium and magnesium scale, hard water scale and variety of deposits.

Industry Applications

Suggestion ::: Our daily descaling works helps to share helpful tricks to dissolve hard scale easily, Always use 5-10 %  our new generation hard scale deposit remover powder RXSOL-11-1102-025 . Addition of RXSOL-11-1102-025 helps to clean 100% scale from system .
 

RXSOL AC2 DESCALEX Powder is classifed in Decaling Chemicals
 
RXSOL AC2 DESCALEX Powder MOST COMMONLY used for evaporators, boilers, cooling towers, coils, plumbing system, heat exchangers and pipes.
 
RXSOL AC2 DESCALEX Powder dissolves water scales cleans microorganisms deposits and other impurities. 
 
RXSOL AC2 DESCALEX Powder developed by additon of such ingredients which effectively chemically penetrate to loose scales deposit Also RXSOL AC2 DESCALEX Powder contains corrosion inhibitor to protect from RUST. RXSOL AC2 DESCALEX Powder provides corrosion protection even after the cleaning
 
RXSOL AC2 DESCALEX Powder hleps to keep system scale and deposits free which improves heat transfer efficiency in heat exchangers and improve flow in pipes.
 
RXSOL AC2 DESCALEX Powder chemically reacts with calcium and magnesium scale to dissolves hard water scale deposits.
 
RXSOL AC2 DESCALEX Powder Super contains pH indicator which facilitate monitoring of cleaning progress.

Safety Data (MSDS)

Product Name : RXSOL-15-1008
Product Type : Descale Powder

Company Details:

RX MARINE INTERNATIONAL
105, A wing , BSEL , TECH PARK.
VASHI ,NEW BOMBAY 400703 INDIA

Stock Point ::: Mumbai, Gandhidham, Kolkata, Muscat - Oman, Fujairah Middle East, Chennai, Visakhapatnam, 

Phone : +91 22 27815541 / 42
Fax : +91 22 2781 1318 :::AOH :0091 9821214367
Email : mail@rxmarine.com

Chemical Name Concentration CAS Number EC Number R Phrases* Symbols
Sulphamic inhibitor blended acid        60-100 5329-14-6 226-218-8 36/38, 52/53 x
Non classified ingredients 1-10        

*See Section 16

irritant

Irritant

Odour

Characteristic odour

Appearance

crystals, orange, soluble in water

Contact with eyes

Causes severe irritation

Contact with skin

In cases of severe exposure, irritation may develop

Inhalation

Irritating to respiratory system (R37)

Ingestion

The ingestion of significant quantities may cause burning sensation

Harmful to aquatic organisms, may cause long-term adverse effects in the aquatic environment (R52/53)

Contact with skin

Wash affected area with plenty of soap and water.Contaminated clothing should be laundered before reuse.Seek medical attention if irritation persists

Contact with eyes

If substance has got into eyes, immediately wash out with plenty of water for at least 15 minutes.Irrigate eyes thoroughly whilst lifting eyelids.Obtain immediate medical attention

Ingestion

Do not induce vomiting.Never give anything by mouth to an unconscious person.Give water or milk to drink.Obtain immediate medical attention

Inhalation

Inhalation is unlikely to occur.Remove patient to fresh air 

evision:31.12.2008

When in doubt or symptoms persist, seek medical attention

General

In case of accident or if you feel unwell, seek medical advice immediately (show the label where possible) (S45)

-   Non-combustible solid
-   Smoke from fires is irritating
-   Not flammable. In case of fire use extinguishing media appropriate to surrounding conditions
-   Prevent run off water from entering drains if possible

Personal Precautions

Wear protective clothing as per section 8

Environmental Precautions

Do not allow to enter public sewers and watercourses

Clean Up Actions

Sweep or shovel-up spillage and remove to a Wash spill site with water and detergent

Special Precautions

Wear protective clothing as per section 8

Handling

Wear protective clothing as per section 8
In use, may form flammable/explosive vapour-air mixture (R18)
Ensure adequate ventilation
Avoid contact with skin and eyes (S24/25)
Eyewash bottles should be available

 Storage

Keep only in the original container in a cool, well ventilated place (S3/9/49) Keep in acid store

Exposure Limits

There are no recommended or established controls for this product

Exposure controls

No special precautions are required for this product

Occupational exposure controls

Wear suitable protective clothing, including eye/face protection and gloves (plastic or rubber are recommended).Wear suitable dustmask e.g.to BS 2091

gloves              suit               goggles               no_smoking

Gloves                    Suit                      Goggles              No_Smoking

Odour Characteristic odour
Appearance crystals, orange, soluble in water
pH 1 at 10 % concentration
Boiling point not applicable
Vapour pressure not known
Melting point 205 °C at 760 mm /Hg
Water solubility ~ 200 g/l
Density 1200 kg/m3
Non-combustible solid

-   This article is considered stable under normal conditions, In use, may form flammable/explosive vapour-air mixture (R18), Reaction products may include hydrogen
-   Avoid overheating
-   Incompatible with alkalis (strong bases)
-   Contact with nitrite (e.g. Diesel DEWT Guard NB NB, ROCCORRX NB Liquid) liberates toxic gas.

 

Toxicological information

LD50 (oral,rat) 3160 mg/kg

Inhalation

May cause severe irritation
May cause shortness of breath

Contact with skin

May cause irritation

Contact with eyes

Causes severe irritation

Ingestion

The ingestion of significant quantities may cause burning sensation

Carcinogenicity

No evidence of carcinogenic effects

 

Ecotoxicity

Harmful to aquatic organisms, may cause long-term adverse effects in the aquatic environment (R52/53)

Mobility

Completely soluble in water

Persistence and Biodegradability

Most components in this product are not readily biodegradable.

Bioaccumulation Potential

Bioaccumulation of the components in this product is insignificant.

Other Adverse Effects

No environmental problems are expected when the product is used / handled correctly.In its intended use, the product will not be released into the environment.

 

Classification

EU Waste class: 06.01 This material and/or its container must be disposed of as hazardous waste

Disposal considerations

Do not discharge into drains or the environment, dispose to an authorised waste collection point Disposal should be in accordance with local, state or national legislation

Proper Shipping Name
UN        
  Proper Shipping Name

Sulphamicacid, mixture

   
  UN NO.

2967

   
  Hazard Class 8 PackingGroup III

Road/Rail(ADR/RID)

  Proper Shipping Name

Sulphamicacid, mixture

   
  ADR UN No.

2967

   
 

ADRHazardClass

8 Tremcard

80GC2-III

Sear (IMDG)
  Proper Shipping Name

Sulphamicacid, mixture

   
  IMDG UN No.

2967

   
  IMDG Hazard Class 8 ICAO PackingGroup

III

  IMDG EmS F-A, S-B IMDG subrisk

N/A

 

IMDG Labels

8

IMDG Flashpoint

 N/A

Air(ICAO/IATA)

       
  ProperShippingName

Sulphamicacid, mixture

   
  ICAO UnNo

2967

   
  IMDG HazardClass 8 ICAO PackingGroup

III

  ICAO subrisk N/A ICAO Labels

8

  ICAO Flashpoint

N/A

   

DOT/ CFR(USDepartment ofTransportation

       
 

DOTProperShippingName

Sulphamicacid, mixture 

   
 

HazardousMaterial

Sulphamicacid

   
  HazardClass 8 Identification Number UN2967
 

Product RQ (lbs)

N/E DOTsubrisk

 N/A

 

DOT Labels

8

 DOTFlashpoint  N/A

Risk Phrases
 

Irritating to eyes and skin (R36/38).Harmful to aquatic organisms, may cause long-term adverse effects in the aquatic environment  (R52/53)

Safety Phrases
 

In case of  contact  with  eyes,  rinse  immediately  with  plenty  of  water  and  seek  medical advice (S26).After contact with skin, wash immediately with plenty of soap and water (S28).Wear suitable gloves and eye/face protection (S37/39).Avoid release to the environment. Refer to special instructions/Safety data sheets (S61)

Text of R and S phrase codes used in this safety data sheet:-  R36/38: Irritating to eyes and skin;  R52/53:  Harmfulto aquatic organisms, may cause long-term adverse effects in the aquatic environment.The  information provided about the product  on  this  Safety Data  Sheet  has been compiled from knowledge of the individual constituents.The  data given here is based on current knowledge and experience. This Safety Data Sheet describes the product  in  termsof safety  requirements  and  does  not  signify  any  warranty   with  regard  to  the  product's  propertiesThe data  given here   only   applies   when    product   used   for   proper  a pplication(s) .   The   product   is   not    sold    as  suitable for   other   applications  - usage  in  such  may  cause  risks  not  mentioned  in  this  s heet. Do   not   use   for  other application(s) without seeking advice from manufacturer

DISCLAIMER OF LIABILITY :The information in this SDS was obtained from sources which we believe are reliable. However, the information is provided without any warranty, express or implied, regarding its correctness. The conditions or methods of handling, storage, use or disposal of the product are beyond our control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of the product. This MSDS was prepared and is to be used only for this product. If the product is used as a component in another product, this MSDS information may not be applicable.

top