Shop

Liquid Browning, Coffee Free Stain Remover Liquid Coffee and tea are two of the most common spots or stains on carpet and upholstery. Liquid Browning/Coffee Free was especially formulated to make the removal easier for the professional. It will attack both coffee and other tannin stains quickly and effectively. Tannin is naturally found in tea, and sometimes added to inks and dyes. This solution is effective on new or old stains.

DIRECTIONS : Deirectly apply RXSOL Liquid Browning, Coffee Free Stain Remover to affected area. DO NOT MIST. Do not dilute.

For Large Area you can use sprayer for UNIFORM distribution. Allow RXSOL Liquid Browning, Coffee Free Stain Remover solution to dwell until browning is reduced or disappears.

Then Extract with portable or truck-mounted system with fresh water.

 

For  spots cleaning, apply solution straight (Do not dilute) to a clean white cloth. Then  thoroughly wet stain with the saturated cloth.

 

Product Name	Liquid Browning, Coffee Free
Product Type	RXSOL-41-8816-025

Company Details:
RX MARINE INTERNATIONAL
105, A wing , BSEL , TECH PARK.
VASHI ,NEW BOMBAY 400703 INDIA

Stock Point : Mumbai, Kandla, Kolkata, Chennai, Visakhapatnam, Fujairah, Barka - Oman, Kenya

Phone	+91 22 27815540  /  41  / 42
Fax	+91 22 2781 1318 :::AOH :0091 9322594669
Email	mail@rxmarine.com

Hazardous Ingredient                 CAS                OSHA PEL               OSHA HAZARD

SodiumMetabisulfite (CAS# 7681-57-4)                N/E                                 N/E

Emergency Overview

Primary Entry Routes: Inhalation

Target Organs: Respiratory system, eyes, skin

Acute Effects: Acute effects to exposure of sodium metabisulfite includes eye and mucous membrane irritation. Acute poisoning from sulfur dioxide is rare because the gas is easily detected. It is so irritating that contact cannot be tolerated. Symptoms include coughing, hoarseness, sneezing, tearing, and breathing difficulty.

Inhalation: Irritant

Eye: Irritant

Skin: Irritant

Exposure Route Symptom Treatment

Inhalation: Sore throat, shortness of breath Remove from exposure to fresh air coughing, and congestion.
Seek medical attention in severe cases or if recovery is not rapid.

Eye Contact: Irritation to eyes and mucous Irrigate with water until no evidence membranes. of chemical remains. Obtain medical attention.

Skin Contact: Irritation, itching, dermatitis Wash with soap and drench with water.

Remove contaminated clothing and wash before reuse.

Ingestion: Irritation to mucous membranes. Give large quantities of water or milk immediately. Obtain medical attention.

After first aid, get appropriate medical attention.

Note to physician: Exposure may aggravate acute or chronic asthma, emphysema and bronchitis. Special Precautions/Procedures: None indicated.

 Flash Point:                                                      Not combustible.

Flash Point Method:                                         Not Applicable.

Burning Rate:                                                    Not Applicable.

Autoignition Temperature:                               Not Applicable.

LEL:                                                                    Not Applicable.

UEL:                                                                    Not Applicable.

Flammability Classification:                            Not Flammable.

Extinguishing Media:                                       Use extinguishing agent appropriate for

Surrounding fire conditions.

Unusual Fire or Explosion Hazards:                None indicated.

Hazardous Combustion Products:                   May release hazardous gas.

Fire-Fighting Instructions:                                Do not release runoff from fire control

methods to sewers or waterways.

Fire-Fighting Equipment: Because fire may produce toxic thermal decomposition products, wear a self-contained breathing apparatus (SCBA)
with a full face piece operated in pressure-demand or positive-pressure mode.

 Spill Procedures: Wear appropriate PPE - See Section 8.

 Small Spills: Spills can be swept and diluted with water for disposal.

Handling Precautions: Avoid contact with product. Do not breath dust or vapor.

Storage Requirements: Avoid heat or moisture. Store in areas, away from heat and moisture and protected from physical damage. Segregate
from acids and oxidizers.

 Ventilation:

Provide general or local exhaust ventilation systems to maintain Airborne concentrations below OSHA limits (Sec. 2). Local exhaust ventilation
is preferred because it prevents contaminant dispersion into the work area by controlling it at the source.

Respiratory Protection:

Follow OSHA respirator regulations (29 CFR 1910.134) and, if necessary, wear a MSHA/NIOSH-approved respirator. Select respirator based on
its suitability to provide adequate worker protection for given working conditions, level of airborne contamination, and presence of sufficient oxygen.

Protective Clothing / Equipment:

Wear protective gloves, boots, and clothing when necessary to prevent excessive skin contact. Wear protective eyeglasses or goggles,
per OSHA eye- and face-protection regulations (29 CFR 1910.133). Contaminated Equipment: Remove this material from personal protective

Odor :	Pungent SO2 odor
Physical State:	Liquid
Appearance:	Clear
pH as 1% solution:	2.0
Specific Gravity :	1.0504
Boiling Point:	N/E
Freezing/Melting Point:	N/E
Vapor Pressure:	N/E
Vapor Density:	N/E
Solubility in Water:	Complete

Stability: Stable under normal conditions.

Polymerization: Hazardous polymerization will not occur.

Chemical incompatibilities: In the presence of water, or acid, Sodium Metabisulfite (and solutions) may release toxic and hazardous fumes of sulfur oxides, including sulfur dioxide. Acute poisoning from sulfur dioxide is rare because the gas is easily detected. It is so irritating that contact cannot be tolerated. Symptoms include coughing, hoarseness, sneezing, tearing, and breathing difficulty. Contact with powdered potassium, sodium metals, alkali, and oxidizing agents produce violent reactions. Reacts with water and steam to form corrosive sulfurous acid. Reacts with chlorates to form unstable chlorine dioxide. Conditions to Avoid: Avoid excessive heat, or open flame, and moisture. Hazardous Decomposition Products: May release hazardous sulfur dioxide gas.

Eye Effects (rabbit): Not available.

Acute inhalation Effects (rat): Not available.

Skin Effects (rabbit): Non-corrosive.

Acute Oral Effects (rat): LD50 = 115 mg/kg

Chronic Effects: Prolonged or repeated exposure may cause dermatitis, and Sensitization reactions. Exposure to asthmatic, atopic and sulfite sensitive individuals may result in severe bronchoconstriction and reduced levels in forced expiratory volume.

Ecotoxicity: bisulfite is a non hazardous liquid commonly used as a waste water dechlorinating agent. High concentrations will contribute to elevated chemical oxygen demand in aquatic environments.

Environmental Transport: Soluble in water.

Environmental Degradation: Rapid biological decomposition.

Soil Absorption/Mobility: Slight.

Contain with chemical absorbent material. Do not dispose of on the land, in surface waters, or in storm drains. Small spills and waste may be flushed into a waste treatment sewer where local regulations permit. Larger quantities should be collected for reuse or consigned to a licensed hazardous waste hauler for disposal in accordance with federal, state and local regulations.

All disposal must be in accordance with all federal, state and local regulations.

No restrictions for Ground, Air, or Maritime Transportation in accordance with 49 CFR parts 100-185.

 All components are listed on TSCA.

This product has no established regulatory information. All regulatory information given is based on individual components of the mixture by
component number. While this information and recommendations set forth herein are believed to be accurate and reliable, it is provided without
warranty regarding its accuracy.

RX MARINE INTERNATIONAL MAKES NO WARRANTY WITH RESPECT HERETO AND DISCLAIMS ALL LIABILITY FROM RELIANCE THEREON.

Users must determine safe conditions for use and assume liability for any loss, injury, damage or expense resulting from use of this product.

N/A = Not applicable N/D = Not determined N/E = Not established

DISCLAIMER OF LIABILITY :The information in this SDS was obtained from sources which we believe are reliable. However, the information is provided without any warranty, express or implied, regarding its correctness. The conditions or methods of handling, storage, use or disposal of the product are beyond our control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of the product. This MSDS was prepared and is to be used only for this product. If the product is used as a component in another product, this MSDS information may not be applicable.