Scale Inhibitor Antiscalant

Very power full superior product which making the film to protect the Corrosion and antiscalant in Pipe line and equipment where supplies hot and cold water.

SKU: RXSOL-33-2034-030 Category:

Description

Antiscalant C.I ALKA is very power full superior product which making the film to protect the Corrosion and antiscalant in Pipe line and equipment where supplies hot and cold water.

SUPERIOR ANTISCALANT AND DISPERSANT FOR HIGH STRESS COOLING WATER APPLICATIONS…






Product Details

Application

Antiscalant C.I ALKA is a special formulated Product by  liquid silicate and inorganic polyphosphates can Food that is used in the treatment of fresh  hot and cold water, for protect the corrosion and scale deposit in Pipe line and Equipment. This significantly reduces the corrosion which caused by aggressive water and promotes the formation of a protective film. Prevents the precipitation of calcium and magnesium in water.

Dosage & Procedure

For natural waters "normally mineralized" (up to 500 mS / cm). Recommended starting dose of 40 g / m, after the formation of protective film is sufficient.

A maintenance dose of 20 g / m³.

With salt water is very necessary to increase the dose above which can reach, in the case brackish water, even up to 200 g / cm.

Technical Specifications

Odour

Odourless

Appearance

Liquid, Clear

pH

11.5  at 100 % concentration

Boiling point

100 °C at 760 mm /Hg

Vapour pressure

not known

Freezing point

 <0 °C at 760 mm/Hg

Completely soluble in water

 

Specific gravity (water=1)

1.15 - 1.7

   

Notes & Precautions

RO antiscant

Scaling is caused in membranes because the level of hardness salts in the water becomes highly concentrated as it passes through the RO unit. In smaller units scale formation can be prevented by base exchange softening the make-up water but for larger systems that is very expensive. We have developed a range of easy to handle, cost effective RO Antiscalant which increase the solubility of the hardness salts so they remain in solution rather than forming scale on the membrane. Our cost effective RO antiscalants will inhibit a wide range of foulants including: calcium carbonate, calcium sulphate, barium sulphate, strontium sulphate, calcium fluoride, silica and iron.

RO Antiscalants are dosed directly to the RO feed water tank or feed water line (after pretreatment) at the recommended dosage of 1-3 mg/L and maximum dosage at 8mg/L, subject to inlet water quality and parameters is respect of Calcium Hardness, Iron, TDS, Alkalinity, pH and silica content. Maximum dilution should be 10% with RO or DI water for temperature less than 30 deg C. For higher temperature the dilution ratio can increase. 

Key Features and Benefits

  • Inhibit scale formation and effectively controls corrosion
  • Protects the membrane efficiently
  • Enhance the plant operation and equipments life span
  • Economical
  • Easy in usage and handling
 
Our RO Antiscalant (HIGH PH) is a super-threshold RO membrane antiscalant and antifoulant which is able to stabilize a wide range of supersaturated salt solutions, thereby preventing the precipitation on the membrane surface. 


It reduces the risk of scaling and eliminates the use of hazardous acids,resulting in efficient plant operation with highest possible conversion rate. 

It is a very effective antiscalant . It is also compatible with RO CHEMICALS series of coagulant and flocculants (polyelectrolytes). Our RO Antiscalant (HIGH PH) is effective in minimizing scaling in presence of foulants like Calcium Carbonate, Sulfate salts of Calcium, Barium, Strontium and Magnesium, Calcium Fluoride, Iron and Silica.

Key Features and Benefits

  • Effective scale inhibition 
  • Alkalinity builder 
  • High recovery rate 
  • Low Chemical dosage 
  • Cost Effective 
  • Effective Iron fouling control by sequestration 
  • Reduced frequency of membrane cleaning 
  • Compatible with all types of membranes 
  • Completely organic and biodegradable 


Application and Dosage
Our RO Antiscalant (HIGH PH) is dosed directly to the RO feed water tank or feed water line (after pretreatment) at the minimum recommended dosage of 1ppm and maximum dosage at 15ppm, subject to inlet water quality and parameters is respect of Calcium Hardness, Iron, TDS, Alkalinity, pH and silica content. 

In case of high iron content of about 0.5 to 1.0ppm, the dosing has to be increased by 10-15ppm for stabilizing Calcium. 

At about 10-15ppm dosage our RO Antiscalant (HIGH PH) is capable of fully inhibiting iron and calcium, and silica up to 166ppm. For higher silica content RXSOL ANTISCALANT should be used. 

Antiscalant RO                                   RXSOL-33-3302-025
Antiscalant C.I ALKA                          RXSOL-33-2034-025
Membrane Antiscalant ALKA 191T    RXSOL-33-3321-030 
Antiscalant ORG EV 2030                 RXSOL-33-3325-230
Antiscalant RXSOL ORG EV             RXSOL-33-3327

Active Matter

55 - 58 %

Generic / Chemical Name

Scale Inhibitor Antiscalant

Supply Locations

Antiscalant for COLD and HOT water circulation system manufacturer and supplier in India UAE Oman Sudan Kenya Yemen. Antiscalant for COLD and HOT water circulation system major supplier in Mumabi, Fujairah, Muscat, Nairobi, Kolkata, Chennai, Visakhapatnam, Gandhidham Surat Gujrat, Andhrapradesh, Tamilnadu, Westbengal, Dubai, Sharjah, Ajman, Abudhabi, Ruwi, Fujairah, Barka

Safety Data (MSDS)

 

Product Name : RXSOL Antiscalant C.I
Product Type : Scale Inhibitor Antiscalant

Company Details:
RX MARINE INTERNATIONAL
105, A wing , BSEL , TECH PARK.
VASHI ,NEW BOMBAY 400703 INDIA 

Stock Points: Mumbai, Kandla, Kolkata, Chennai, Visakhapatnam, Fujairah UAE, Muscat Oman, Kenya, Canada

Phone : +91 22 65113333 / 5555 / 9999 / 27611360
Fax : +91 22 2781 1318 :::AOH :0091 9821214367
Email : mail@rxmarine.com

Chemical Name CAS Number LD 50 (Oral Rat)
Co polymer of acrylic acid Proprietary > 5000 mg/kg
Acryl amido methyl propane sulphonic acid 15214 –89 -8 1410 mg/kg
Acrylic terpolymer Proprietary

> 5000 mg/kg

Polymaleic acid 26099– 09 -2 15000 mg/kg
Maleic acid 110-16-7 15000 mg/kg

Odour

Odourless

Appearance

Liquid, Clear

Contact with eyes

Mildly irritating to eyes

Contact with skin

In cases of severe exposure, irritation may develop

Inhalation

Vapours or aerosols may cause irritation of eyes, nose and respiratory tract

Ingestion

May cause gastro-intestinal disturbances

Contact with skin

Remove contaminated clothing immediately and drench affected skin with plenty of water. The wash with soap and water.Seek medical attention if irritation persists.

Contact with eyes
 

If substance has got into eyes, immediately wash out with plenty of water for at least 15 minutes.Seek medical attention if irritation persists.

Ingestion

Never make an unconscious person vomit or drink fluids.Give water or milk to drink.When in doubt or symptoms persist, seek medical attention

Inhalation

Inhalation is unlikely to occur.Remove patient to fresh air.

General

In case of accident or if you feel unwell, seek medical advice immediately (show the label where possible).

-   Non combustible
-   None
-   Not flammable. In case of fire use extinguishing media appropriate to surrounding conditions

Precautions

Wear protective clothing as per section 8

Immediate Actions

Shut off source of leak if safe to do so

Clean Up Actions

Flush spill area with copious amounts of water

Special Precautions

Wear protective clothing as per section 8 No special precautions are required for this product

 Handling

The usual precautions for handling chemicals should be observed

 Storage

Keep only in the original container in a cool, well ventilated place (S3/9/49) Protect from frost

Exposure Limits

There are no recommended or established controls for this product.

Exposure controls

No special precautions are required for this product.

Occupational exposure controls

Wear suitable protective clothing, including eye/face protection and gloves (plastic or rubber are recommended).

Odour

Odourless

Appearance

Liquid, Clear

pH

3-6  at 100 % concentration

Boiling point >

100 °C at 760 mm /Hg

Vapour pressure -

not known

Freezing point

 <0 °C at 760 mm/Hg

Completely soluble in water

 

Specific gravity (water=1)

1.05 - 1.12

Non combustible

 

No hazardous decomposition products known . Avoid overheating, Keep away from frost.

Inhalation

Inhalation is unlikely to occur

Contact with skin

In cases of severe exposure, irritation may develop

Contact with eyes

In cases of severe exposure, redness and irritation may develop

Ingestion

May cause gastro-intestinal disturbances

Carcinogenicity

No evidence of carcinogenic effects

Mobility

Completely soluble in water

Bioaccumulation Potential

Bioaccumulation of the components in this product is insignificant.

Other Adverse Effects

Presents little or no hazard to the aquatic environment.

Classification

EU Waste class

Disposal considerations

Do not discharge into drains or the environment, dispose to an authorised waste collection point - Disposal should be in accordance with local, state or national legislation

Not classified as hazardous for transport

Classification and labelling

Not classified as hazardous for users

Risk Phrases

Not applicable

Safety Phrases

Not applicable

The information provided about the product on this Safety Data Sheet has been compiled from knowledge of the individual constituents The data given here is based on current knowledge and experience. This Safety  Data Sheet describes the product in terms of safety requirements and does not signify any warranty with regard to the product's properties The data given here only applies when product used for proper application(s). The  product is not sold as suitable for other applications - usage in such may cause risks not mentioned in this sheet. Do not use for other application(s) without seeking advice from manufacturer.

DISCLAIMER OF LIABILITY :The information in this SDS was obtained from sources which we believe are reliable. However, the information is provided without any warranty, express or implied, regarding its correctness. The conditions or methods of handling, storage, use or disposal of the product are beyond our control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of the product. This MSDS was prepared and is to be used only for this product. If the product is used as a component in another product, this MSDS information may not be applicable.

top